Specification
Types
- Type A: Exterior hinge leaf
- Type I: Interior hinge leaf
Coding
- Coding C: With countersunk holes
Hinge leaf
Aluminum
Anodized, natural color EL
Bearing bushing / Cover cap
Plastic, Polyamide (PA)
Graphite gray, RAL 7024
Tapered dowel pin ISO 8741
Steel
Zinc plated, blue passivated
Information
Hinges GN 2295 are made of drawn profiled aluminum and are used on doors and covers, for example.
Given the external hinge wing, type A hinges allow mounting with a very small door gap. The type I is fastened in the door gap. The mounting screws are therefore inaccessible and hence protected from vandalism when the door is closed.
The hinges are delivered loose and must be mounted according to the accompanying instructions. Any hinge combination may be realized (if needed, also by shortening the middle wing) thanks to the modular design and available accessories.
Mounting information
Left / right hinges
Right or left hinges can be created by the direction in which the bearing bushings are inserted into the hinge leaf.
Mounting on door frames
For mounting a door that should be removable, two hinges of the same type must be attached to the door frame.
If the door is not supposed to be removable, the door must be mounted with at least one right hinge and at least one left hinge.
Mounting
1. Position the bearing bushing with the desired installation direction on the hinge leaf. Then insert a screw with a collar such as socket button head screws ISO 7380 into the bearing bushing to protect the bearing bushing collar from damage while pounding in.
2. Pound in the bearing bushing until about 1 mm remains between the bearing bushing collar and the hinge leaf.
3. Remove the burr on the bearing bushing using a knife.
4. Pound in the bearing bushing all the way.
5. Remove the screw.
6. Pound a tapered dowel pin into the bearing bushing.
7. Place the cover cap on the opposite side of the hinge leaf.
Insert the other bearing bushings according to points 1 to 5.
